Alabama Damascus Paring Blade
Material = 5160, 15n20, Ni200 - 416 layer damascus
Blade = 3/4" x 3-1/4" Long Grind
Overall Length = 6-1/2"
Full Tang
1/8" Hole
Blade has been Precision ground, Laser cut, Hollow ground, Heat-treated to 58-60 Rc, & Etched
This blade just needs a final edge and some handles.
Posted by Drew K, DJK_Knives on 24th May 2023
I just love Lacy's work. These blanks are beautiful and look incredible with finished builds. Gorgeous Damascus patterns.
Posted by Rick Waters on 28th Jan 2022
Doing business with them for over 5 years and always the best.
Posted by Unknown on 30th Jan 2021
New to knife building. The finished knife looks good.
4 stars. Maybe I had too high of expectations. Many scratch marks across the blade - below the Damascus etching. I think this blade could have been sanding/polished better. The "zoom in" for this blade on the website even shows the type of scratches. Maybe I should have expected scratches.
The blade was not sharp. One side of the cutting edge was at about 30 degrees, the other side was about 20 degrees. Fortunately not a problem. I like sharpening knives.
Suggestions - publish the pin hole diameters and the recommended edge angle.
Posted by steve on 26th Oct 2020
Shipping sucked but it was USPS fault. The blades looked good when they came in pretty sharp wish one of them were a little more even grind with the others however not a big deal. I will be ordering again.
Posted by Ben on 21st Oct 2020
With handles from a winter-damaged laurel hedge in our backyard. Gifted one to each of 4 sons. Beautiful damascus patterns on these.
Posted by Dick on 12th Nov 2019
Another great damascus blade